LTE Tracking Area Update vs. UMTS Location/Routing Area Update

WirelessMoves | Here’s an interesting piece of technical insight I gained this week when going through 3GPP TS 23.401 concerning tracking area updates that I haven’t seen when I went through the spec

WirelessMoves | Here’s an interesting piece of technical insight I gained this week when going through 3GPP TS 23.401 concerning tracking area updates that I haven’t seen when I went through the spec for my SAE review posts back in February (part 1, part 2 and part 3):

In UMTS, location area and routing area udpates are only done when the mobile is in idle state, i.e. no physical link is established on the high speed shared-, dedicated- or forward access channel. This makes sense as in these states the RNC in the access network is aware of the location anyway and can report location changes to the core network when necessary. Only once the mobile goes to idle state and the mobile makes the decision to go to another cell on its own without reporting back, routing and location area updates come into play if the new cell is outside the current area.

In LTE, the corresponding procedure is called a tracking area update. The first difference to the LAU and RAU of UMTS is that the mobile can have a list of several valid tracking areas and an update only has to be made if the new cell is in a tracking area that is not part of that list. So far so good. TS 23.401 chapter 5.3.3.0 says, however, that a tracking area update is made in both idle and connected state. Quite a surprise to me so I wondered why an update is necessary in the connected state!?

read more

Leave a comment

Your email address will not be published. Required fields are marked *